#Cgminer 3.8.5 download password
The function is available in the config multiplier.Ĩ) Fixed the problem with DevFee error exit.Ģ) Modified and changed the method of connecting to pools.ģ) Added the function of mass password change in the config multiplier.Ĥ) Added the function of mass change of Ssh port and mass shutdown of Ssh in the config multiplier.ģ) Fixed a bug when on some batches the ASIC did not connect to the pool.Ģ) Fixed a bug when the ASIC could freeze during auto tuning or when the timer was triggered.ģ) Fixed installation and connection to Anthill service.Ĥ) Optimization of the firmware file size, which could lead to the error: No space left on device.ĥ) The method of treating the new virus has been improved, which corrupts the recording files and does not allow flashing even through SSH.Ħ) A new subsection (security) has been added to it.
#Cgminer 3.8.5 download manual
If during the flashing process via the SD card you see that 2 lamps (green and red) on the control board are on and do not blink, then most likely your control board is infected with the ANTBUILD virus, you must use a special image ANTBUILD_RECOVERY to block the virus.įirmware AntMiner S9 (Low Power Mode) Release 3.8.6 SD Image AntMiner S9 (Low Power Mode) Release 3.8.6ġ) Added a unique PROTECTION!!! On the hardware level against Antbuild and all similar viruses forever!!!Ģ) Added the option hotel fii (where you can redirect part of the capacity to pay for electricity, equipment placement or pay for miners' maintenance).ģ) Added option to enable LPM mode (voltage reduction during mining).Ĥ) Changed the visual display of the hash boards (it is easier to physically find the hash board in the miner).ĥ) Added the ability to reduce the voltage on hash boards to 7.9 volts.Ģ) Added the ability to choose between a full restart of the ASIC and the restart of only the cgmeiner in tune.ģ) In addition to the automatic virus scanning system, Added manual scanning and disinfection in the Security section, including the new AntBuild virus.Ĥ) Fixed connection to monitoring Anthill.farm.ĥ) Added the Find Miner function to the multiplier config to search for more miners at once.Ħ) Changed the format of downloading the log file in txt.ħ) a new function "sleep mode" when it is turned on, mining stops and the fans go down to minimum speed. You can see the firmware version in the System - file system version section.
#Cgminer 3.8.5 download download
If you have BITMAIN June 2019 and earlier firmware installed, you can remove the protection using the "signature" file, if you have the firmware on July 31, 2019, you can remove the protection using the "signature_31july" file and then download our firmware or use the SD card (all files are posted on the site and instructions). If, when changing the BITMAIN firmware, you see the message: can not find signature, this means that your equipment has the 2019 BITMAIN firmware installed, in which the overwrite protection is installed, the 2018 firmware does not have this protection. ATTENTION: The firmware is suitable for all ASICs S9 (Low Power Mode).
0 kommentar(er)
